Get quotes
TL-05, free tool

Conveyor Belt Roll Calculator

How much belt is left on that roll in the yard? How big and heavy will a 300 m roll be on the truck? Enter the belt thickness and either the roll diameter or the length.

Roll length, diameter and mass

Switch between the two modes with the first field.

Steel or wooden core; about 300 mm is common. Use the hole size for a coreless roll.
Covers plus carcass. EP630/4 6+2 is about 13 mm; the decoder estimates it.
Result–
Belt on the roll
– m
Roll diameter
– mm
Number of wraps
–
Roll mass, belt only
– kg
Mass per metre
– kg/m

A roll of conveyor belt is a tight spiral, so its diameter, length and thickness are tied together by simple geometry. That lets you check how much belt is left on a part-used roll, or plan cranage and transport for a new one, without unrolling anything.

The roll formulas

  • Length from diameter: L = π × (D² − d²) ÷ (4t)
  • Diameter from length: D = √(4 × L × t ÷ π + d²)

D is the outside diameter, d the core diameter and t the belt thickness, all in metres. The result assumes a tightly wound roll; a loosely wound roll holds less belt than its diameter suggests, so measure several diameters and use the smallest.

Estimating mass

Rubber belts with a fabric carcass weigh about 1.15 to 1.35 kg per m² per mm of thickness; the calculator uses 1.25 unless you enter a figure from the datasheet. Steel-cord belts are much heavier for their thickness, so always use the manufacturer's kg/m² for ST belts. As a guide:

  • EP400/3, 5 + 1.5 mm covers: about 9 kg/m²
  • EP630/4, 6 + 2 mm covers: about 15 kg/m²
  • EP1000/5, 8 + 3 mm covers: about 21 kg/m²
  • ST1600, 8 + 6 mm covers: about 30 kg/m²

Handling and storing rolls

Lift rolls with a spreader bar through the core or with slings around the roll, never by the belt edges. Store them on their core on a stand or on a flat, dry surface, out of direct sun and away from ozone sources such as welding machines, and turn them every few months on long storage. Rolls laid flat on their side for months can dish and run off-track when fitted. If you are buying used belting, ask for the roll's thickness and measured diameter so you can check the length yourself.

Frequently asked questions

How much does a roll of conveyor belt weigh?
A 1 200 mm wide, 200 m roll of EP630/4 6+2 belt weighs about 3.6 t. A 600 mm wide, 100 m roll of EP400/3 weighs about 550 kg. Enter your belt above for a closer figure.
How long is a standard roll?
Suppliers commonly stock rolls of 100 to 300 m, depending on width and rating, and cut to length. Long belts for big mining conveyors are made to order in lengths limited by roll size and transport.
How do I measure belt thickness?
Measure at a cut end or the edge with a vernier, away from worn areas. On a worn belt, the original thickness is on the marking or the datasheet; the difference tells you how much top cover is left.

Get quotes for what you have sized

Used the figures above to size a belt, drive or conveyor? Press Ask for quotes with these figures in the calculator and they are copied into the quote form at the bottom of this page. A supplier or contractor who works in your area replies directly.

More calculators and guides

Get free quotes